- This line was added.
- This line was removed.
- Formatting was changed.
Fine tune the position of textures mapped to your mode with the texture move tool. The tool is accessed from the texture tab within the material editing menu, and it is available when in Planar, Box, Cylindrical and Spherical mapping modes.
Use this to establish exactly where you want the center of your texture image to project. Once in position mode, you can simply click on the surface of the model to change the where your texture is projecting.
Use arrow handles to move the texture mapping position on the XYZ axes. To translate the mapping, click on any of the three axis arrows. The red, green and blue arrows correspond to the X, Y and Z axes.
Use circle handles to rotate and align the texture mapping to your model. Hold SHIFT to constrain the rotation to 15 degree increments.
Select if the translation/rotation should use the global or the local axis.
Fit the texture to match geometry on the X,Y, Z axis.
- Model - This will position the texture relative to the model.
- Part - This will position the texture relative to the part.
Cancel or Confirm Changes
After adjusting the texture mapping with the mapping tool, click the green check mark to confirm the changes and close the mapping tool. Click the red X to cancel the changes and close the mapping tool.
Enable the sync option in the Size and Mapping section to move all your textures on the current material concurrently.
Size and mapping
Use DPI for size
This lets you set the size of the texture in DPI instead of defining width and height.
Width and Height
Sets the width and height of the texture using the current scene unit.
Lock Aspect - Will secure a uniform scale of the texture.
Refresh - Will reset to the original aspect ratio of the texture.
Moves the texture in the U direction. On the example to the right, the UV plane is shown with the orange box, where the V direction is shown with the small arrow. - this means that in the example Shift U will move the texture sideways.
Moves the texture in the V direction. In the example to the right Shift V will move the texture up/down.
This will rotate the UV plane (the orange squares in the example to the right) of the Map
This will rotate the entire map around the local Y axis. This is the same as rotation in the Move Texture tool and means that the entire box will be rotated around the green axis in the example to the right.
Expand the setting for even more precise control.
This will tilt the local axes around the Global X axis.
This will rotate the map around the global Y axis
If the tilt is 0 adjusting the azimuth will be the same as adjusting the overall angle.
Will move the center of the map along the global X axis.
Will move the center of the map along the global Y axis.
Will move the center of the map along the global Z axis.
Will mirrior the texture over the local Y axis.
Will mirror the texture over the local X axis.
This is only relevant for Planar and Box Mapping and has sightly different behavior for the two.
- Planar: When enabled the texture will be visible on both sides of the model, with a mirrored version on the "backside".
- Box: when enabled the texture will be mirrored on the back faces of the box, when disabled the texture is the same on all faces.
When enabled the texture will be tiled horizontally.
When enabled the texture will be tiled vertically.
Textures on this material node with sync enabled will be scaled/moved/adjusted concurrently.
Move texture tool. The Orange squares on the faces of the box are representing the UV coordinates, which can be controlled in the Size and Mapping section.