Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

So your master configuration is set up. The slaves are connected. What now?  Well, before you can send a job to the network, you need to make sure that your computer can “talk” to the master via the queue-master connection. This queue-master connection must be set up within KeyShot Network Monitor on the client’s side.

Client Configuration Instructions

1. Install

Download and Install KeyShot Network Rendering. Follow the prompts and click Finish.

2. Select Monitor

mode

Mode

The configuration wizard appears. Select Monitor only and click Finish (PC) or Done (Mac).







Panel
titleOn this page

Table of Contents
minLevel3
stylenone


3. Establish

connection

Connection

The KeyShot Network Monitor will launch. By default, the connection is set to Auto Detect auto-detect and connect to the Master. 

You may also disable Auto detect auto-detecting the master and specify a Master hostname and the correct Monitor port number, if you wish to specify the Master.

Click Apply. KeyShot Network Monitor will connect to your master.

You can always change your connection settings under  File > Connection Settings.

4. Render...

You can now render over the network.


Info
titleNote

If KeyShot Network Queue cannot connect to your master, then you may contact Luxion Customer Support at support@luxion.com for further assistance.