Fine tune the position of textures mapped to your mode with the texture move tool. The tool is accessed from the texture tab within the material editing menu, and it is available when in Planar, Box, Cylindrical and Spherical mapping modes.
Position Use this to establish exactly where you want the center of your texture image to project. Once in position mode, you can simply click on the surface of the model to change the where your texture is projecting.
Translate Use arrow handles to move the texture mapping position on the XYZ axes. To translate the mapping, click on any of the three axis arrows. The red, green and blue arrows correspond to the X, Y and Z axes.
Rotate Use circle handles to rotate and align the texture mapping to your model. Hold SHIFT to constrain the rotation to 15 degree increments.
Axis Select if the translation/rotation should use the global or the local axis.
Fit Fit the texture to match geometry on the X,Y, Z axis.
Model - This will position the texture relative to the model.
Part - This will position the texture relative to the part.
Cancel or Confirm Changes After adjusting the texture mapping with the mapping tool, click the green check mark to confirm the changes and close the mapping tool. Click the red X to cancel the changes and close the mapping tool.
Enable the sync option in the Size and Mapping section to move all your textures on the current material concurrently.
Size and mapping
Size and Mapping lets you scale and adjust the orientation of the texture. The parameters wary a little with the Texture Types and Mapping Types but the overall options are the same.
Use DPI for size This lets you set the size of the texture in DPI instead of defining width and height.
Width and Height Sets the width and height of the texture using the current scene unit.
Lock Aspect - Will secure a uniform scale of the texture. Refresh - Will reset to the original aspect ratio of the texture.
Shift U Moves the texture in the U direction. On the example to the right, the UV plane is shown with the orange box, where the V direction is shown with the small arrow. - this means that in the example Shift U will move the texture sideways.
Shift V Moves the texture in the V direction. In the example to the right Shift V will move the texture up/down.
Angle UV This will rotate the UV plane (the orange squares in the example to the right) of the Map
Angle This will rotate the entire map around the local Y axis. This is the same as rotation in the Move Texture tool and means that the entire box will be rotated around the green axis in the example to the right. Expand the setting for even more precise control.
Axis Tilt This will tilt the local axes around the Global X axis.
Axis Azimuth This will rotate the map around the global Y axis If the tilt is 0 adjusting the azimuth will be the same as adjusting the overall angle.
Center X Will move the center of the map along the global X axis.
Center Y Will move the center of the map along the global Y axis.
Center Z Will move the center of the map along the global Z axis.
Flip Horizontal Will mirror the texture over the local Y axis.
Flip Vertical Will mirror the texture over the local X axis.
Two Sided This is only relevant for Planar and Box Mapping and has sightly different behavior for the two.
Planar: When enabled the texture will be visible on both sides of the model, with a mirrored version on the "backside".
Box: when enabled the texture will be mirrored on the back faces of the box, when disabled the texture is the same on all faces.
Repeat Horizontal When enabled the texture will be tiled horizontally.
Repeat Vertical When enabled the texture will be tiled vertically.
Sync Textures on this material node with sync enabled will be scaled/moved/adjusted concurrently.
On this page
Move texture tool. The Orange squares on the faces of the box are representing the UV coordinates, which can be controlled in the Size and Mapping section.